Data Entry Menu

After a model has been opened the Data Entry menu will appear on the menu bar. The contents of the menu will vary depending on the type of model.

General Model

If a general model (created using the blank model or wizard) is currently displayed on the desktop the data entry menu will contain the following commands.

General Data - used to edit the general data for the model (title, Darcy velocity, number of layers, and Laplace Transform parameters).

Layer Data - used to edit the data for each layer.

Boundary Conditions - used to edit the top and bottom boundary conditions.

Run Parameters - used to edit the depths and times to calculate the concentrations.

Primary Liner Model

If a primary liner model is currently displayed on the desktop the data entry menu will contain the following commands.

Primary Liner - used to edit the data for the layers and boundary conditions.

Run Parameters - used to edit the depths and times to calculate the concentrations.

Leakage Rate Model

If a leakage rate model is currently displayed on the desktop the data entry menu will contain the following commands.

Leakage Rate Landfill - used to edit the data for the layers and boundary conditions.

Run Parameters - used to edit the depths and times to calculate the concentrations.

Primary and Secondary Liner Model

If a primary and secondary model is currently displayed on the desktop the data entry menu will contain the following commands.

Primary and Secondary Liner - used to edit the data for the layers and boundary conditions.

Run Parameters - used to edit the depths and times to calculate the concentrations.