|
|
|
|
|
After a model has been opened the Special Features menu will appear on the menu bar.This menu contains commands for adding special features to the model.
Radioactive/Biological Decay- used to add either radiological or biological decay to the model.
Initial Concentration Profile - used to add an initial concentration profile to the model.
Non-linear Sorption - used to add either Freundlich or Langmuir Non-Linear Sorption to the model.
Passive Sink - used to add a passive sink to the model.
Time Varying Properties - used to enter time varying properties for the model.
Maximum Sublayer Thickness - used to change the maximum sublayer thickness.
Print mass in the base - used to print the mass in the base when the concentrations are calculated.
Monte Carlo Simulation - used to perform a Monte Carlo simulation on the model.
Sensitivity Analysis - used to perform a Sensitivity Analysis on the model.