|
|
|
|
|
In this tutorial, we have used the auto-generated strata. These strata can be easily edited to your requirements. In this example, we will edit the sand.
To edit the top boundary of the sand, select the Sand strata on the Quick toolbar. The top and bottom boundaries of the sand will then be highlighted in red.
Then to edit the points on the top boundary, click the Edit Points button on the Top tab of the Quick toolbar. The points used to define the top boundary of the sand will be highlighted with blue boxes. There will be one point for each borehole and intersecting cross-section and at the beginning and end of the layer. Select the last point on the right and move it down a bit to make room for a thicker coal.
To finish editing the sand click on the Ok button and then on the Finish Editing button.
Next select the coal strata on the Quick toolbar. Then click on the Edit Points button on the bottom tab. Select the last point on the right of the coal and shift the point down to meet the top of the sand. After the point has been moved click on the Ok and Finish Editing buttons on the Quick toolbar.