|
|
|
|
|
If the Use Default Template option was selected previously, the gINT Default Template Format form will be displayed after the boreholes to import are selected. This form has two tabs, one for Data Format and one for Page Setup.
Data Format Tab
The following information can be entered on the Data Format tab:
Input Units: The user can select to have the input units as either feet or metres.
Output Units: The user can select to have the output units as either feet or metres.
Scaling Factor: The user can select either to scale the template / Log as either Depth / Page or by using a depth scale.
Depth / Page: If the Scaling Factor is Depth/Page then the Depth/Page field will be displayed. This value scales the template / log as a number of metres per page. For example if this value is 20, then there will be 20 metres per page on the log(right).
1 to ___: If the Scaling Factor is Depth Scale then the 1 to ___ field will be displayed. This would allow the depth scale to 1m on screen is equal to ___ metres in real life.
Page Setup Tab
The following information can be entered on the Page Setup tab:
Size: This is the page size of the template. When the arrow at the right is pressed, a list of available page sizes is displayed.
Inches or Millimetres: The units for the width and length of the page. These units will be used when specifying the layout of the legend. If the Page Size is "Custom", the units can be set to either inches or millimetres.
Custom Width: If the page size is specified as "custom", the page horizontal width in inches must be specified.
Custom Length: If the page size is specified as "custom", the page vertical length in inches must be specified.
Orientation: This is the orientation of the page; either portrait (longer side is vertical) or landscape (longer side is horizontal).
When the Ok button is pressed the new template will be displayed on the screen. Then, the imported logs should open up on the screen.