<< Click to Display Table of Contents >> Navigation:  Chapter 4  Boring/Wells > Borings/Wells > Editing a boring/well > Depth Related Data > Grain Size Data

This column is used to display the grain size data at specified depths. There are several ways to edit grain size data, either:

 

•click on the grain size data column on the log

•double click on the grain size data object on the sidebar

•select Edit > Grain Size

•or select Popup > Grain Size

 

After this the Grain Size form will be displayed. At the bottom of this form there are buttons to add and delete measurements.

 

(The appearance of the form will differ slightly depending on if it is WinLoG or WinLoG RT)

 

The following can be edited on this tab:

 

Top Depth: This is the top depth of the grain size measurement.

 

Bottom Depth: This is the bottom depth of the grain size measurement.

 

Grain Size: This is used to select the grain size.