<< Click to Display Table of Contents >> Navigation:  Chapter 4  Boring/Wells > Borings/Wells > Opening a Boring/Well

Boring/Wells can either be opened by selecting it from a list, selecting it on the sidebar, or selecting it on the map.

 

 

Selecting from the Sidebar

 

To select the boring/well from the sidebar either click on it once and then select Popup > Open or double-click on the log on the sidebar.

 

 

Selecting from the Map

 

To select the boring/well from the map, double click on it on the map.

 

 

Selecting from a List

 

 

To select it from a list, select File > Open > Boring/Well or click on the Open button on the main toolbar and then Boring/Well. The Open Boring/Well form below will be displayed.

 

(The appearance of the form will differ slightly depending on if it is WinLoG or WinLoG RT)

 

On the left of this form are lists of the most recently used logs and all the boring/wells. The right side of the form the details of the highlighted boring/well are shown, some of these details are not shown for the most recently used logs. The list of will also show the UWID if the industry type is Oil. At the top of the form is a toolbar that can be used to find a boring/well by specifying the name. To select a boring/well to open, highlight it and then click on the Open button.