<< Click to Display Table of Contents >> Navigation:  Chapter 4  Boring/Wells > Borings/Wells > Editing a boring/well > Depth Related Data > RFT Pressure (Oil & Gas only)

This column is used to display RFT pressure points as symbols.

 

 

There are several ways to edit RFT pressure data, either:

 

•click on the RFT Pressure data column on the log

•double click on the RFT Pressure data object on the sidebar

•select Edit > RFT Pressure

•or select Popup > RFT Pressure

 

After this the RFT Pressure form will be displayed. At the bottom of this form there are buttons to add and delete RFT pressure points.

 

(The appearance of the form will differ slightly depending on if it is WinLoG or WinLoG RT)

 

 

The following can be edited on this form:

 

Depth: This is the depth of the pressure point.

 

Type: This is the type of pressure point.