Groundwater Data Tab

<< Click to Display Table of Contents >>

Navigation:  Chapter 7 Stations and Sampling > Samples > Editing a Sample > Media Data Tabs >

Groundwater Data Tab

Previous pageReturn to chapter overviewNext page

The Groundwater Data tab is used to specify the information that pertains to groundwater media.  These groundwater samples can later be linked to a well log in the WinLoG module using the associated Well specified on the Information tab.

 

clip40914

 

The following can be specified on this tab:

 

Water Depth: This is the depth to the water and depth units.

 

Depth Collected. This is the depth that the sample was collected.

 

Measurement Method: This is the method that was used to measure depths.

 

Monitoring Round: This is used to specify the monitoring round.

 

Volume Collected: This is used to specify the volume collected and the volume units.

 

Color: This is used to select the color from a list of Colors.

 

Odour: This is used to select the odour from a list of Odours.

 

Shine: This is used to specify if there is a shine on the water.

 

LNAPL Present: This is used to specify if an LNAPL is present.

 

LNAPL Depth: If an LNAPL is present, this is used to specify the depth of the LNAPL.