<< Click to Display Table of Contents >> Navigation:  Chapter 9 Geotechnical Data Management > Geotechnical Tests > Entering Test Data > Soil and Aggregates Tests > Classification (Atterberg Limits) > Data Entry > Plastic Limit Data Tab

This tab is used to specify the information for the plastic limit.

 

 

Sets (measurements) can be added and deleted using the Add Set and Delete Set buttons. The measurements for each set consist of the information below:

 

Set: This is the set number and is filled in by the program.

 

Tare with Wet Soil: This is used to specify the mass of the tare and wet soil.

 

Tare with Dry Soil: This is used to specify the mass of the tare and dry soil.

 

Tare Mass: This is used to specify the mass of the tare.

 

Water Content: This is the calculated water content.

 

Difference from Average: This is the difference between the water content and average water content.