<< Click to Display Table of Contents >> Navigation:  Chapter 9 Geotechnical Data Management > Geotechnical Tests > Entering Test Data > Concrete Tests > Concrete Tensile Strength > Data Entry > Concrete Information Tab

This tab is used to specify the information for the concrete specimens.

 

 

The following can be entered and displayed on this tab:

 

Information

 

Specimen Type: This is used to select the type of specimen. It can either be split cast cylinder or split cored cylinder.

 

Specify Dates: Check this box to specify the batch, pour, and test dates (the test dates are specified on the Data & Results tab).

 

Batch Date: If the Specify Dates box is checked, this is used to specify the date and time the concrete was batched.

 

Pour Date: If the Specify Dates box is checked,  this is used to specify the date and time the concrete was poured.

 

Supplier: This is used to select the concrete supplier from a predefined list of suppliers. To get detailed information about the supplier click on the button on the right.

 

Mix Design ID: This is used to select the mix design ID from a predefined mix designs. A datasheet  showing the details of the mix design can be displayed by clicking on the button on the right.

 

Defects: This is used to specify any defects in the specimens.

 

Curing History: This is used to specify the curing history of the specimens.

 

Units

 

Length Units: This is used to select the units for length.

 

Load Units: This is used to select the units for load.

 

Strength Units: This is used to select the units for strength.