Point Tab

<< Click to Display Table of Contents >>

Navigation:  Chapter 5  Boring/Wells > Templates > Editing a Template > Template Columns > Columns Tab > Customizing Columns > Customizing a Graph, Bargraph or Geophysical Column >

Point Tab

Previous pageReturn to chapter overviewNext page

 

clip14441

(The appearance of the form will differ slightly depending on if it is WinLoG or WinLoG RT)

 

The following can be edited on this tab:

 

Type: The graph data can be shown as circles, crosses, squares, squares, triangles, or inverted triangles. To not show the data points, select “none”. If this is a

Bargraph column, the point type is set to “none” and this field will not appear.

 

Size: This is the size of the data points. If the Point Type is set to ‘none’, this field will not appear.

 

Color: This is the color of the data points. To change the color, press the Color button. The Color form will be displayed. This form can be used to select a basic color or a custom color. If the Point Type is set to “none”, this field will not appear.

 

Label Points: The values of the data points can be drawn above each point. If the data value is less than the minimum value, the value will be shown with a “<” symbol. If the data value is greater than the maximum value, the value will be shown with a “>” symbol. If the Point Type is set to “none”, this field will not appear.

 

Decimal Digits: This is the number of digits after the decimal place to use for the label.