Adding a Legend

<< Click to Display Table of Contents >>

Navigation:  Chapter 4  Boring/Wells > Templates > Editing a Template > Legends >

Adding a Legend

Previous pageReturn to chapter overviewNext page

clip14428

 

To add a legend to a template click on the Legend button on the toolbar. Next using the left mouse button click on the location of the upper left corner of the legend. Then while holding down the left mouse button, drag the cursor to the lower right corner of the legend and release the mouse button. The Legend Information form described in the next section will then be displayed. This form can also be used to add a legend using the Add button at the bottom of the form.