Creating a Library

<< Click to Display Table of Contents >>

Navigation:  Chapter 4  Boring/Wells > Lithology Symbol Libraries >

Creating a Library

Previous pageReturn to chapter overviewNext page

Libraries can be created and edited at any time (no project has to be open). To create a library either:

 

Select File > New > Lithology Library

Click the New button on the Main Toolbar and select Lithology Library

 

After this the Create New Lithologic Library form will be displayed.

 

clip0324

(The appearance of the form will differ slightly depending on if it is WinLoG or WinLoG RT)

 

The following information can be entered on this form:

 

Unique Library ID: This is a unique id or name for the library (up to 100 characters).

 

Name: This is the name of the library (up to 255 characters).

 

After the above information has been entered a blank library will be created and displayed. This library will contain 18 blank symbols and descriptions, which can be edited and saved as discussed below.