Adding Lines and Arrows

<< Click to Display Table of Contents >>

Navigation:  Chapter 4  Boring/Wells > Templates > Editing a Template > Draw Objects > Lines and Arrows >

Adding Lines and Arrows

Previous pageReturn to chapter overviewNext page

clip0236

 

To add a line or arrow to a template click on the Line button on the toolbar. Next using the left mouse button click on the location of the starting point of the line or arrow. Then while holding down the left mouse button, drag the cursor to the end of the line or arrow and release the mouse button. The Edit Lines form described in the next section will then be displayed.  This form can also be used to add a line using the Add button at the bottom of the form.