<< Click to Display Table of Contents >> Navigation:  Chapter 4  Boring/Wells > Borings/Wells > Editing a boring/well > Depth Related Data > Diagenesis Data (Oil & Gas only)

This column is used to display the types and percentages of diagenesis at specified depths. There are several ways to edit diagenesis data, either:

 

•click on the diagenesis data column on the log

•double click on the diagenesis data object on the sidebar

•select Edit > Diagenesis

•or select Popup > Diagenesis

 

After this the Diagenesis form will be displayed. At the bottom of this form there are buttons to add and delete depth measurements.

 

(The appearance of the form will differ slightly depending on if it is WinLoG or WinLoG RT)

 

The following data can be edited on this form:

 

Depth: This is the depth of the measurement.

 

Diagenesis: This is the type of diagenesis and percentage at the measured depth. The type and percentage can be selected on the left of the form and entered for the depth using the Add Diagenesis Item.