<< Click to Display Table of Contents >> Navigation:  Chapter 4  Boring/Wells > Borings/Wells > Editing a boring/well > Depth Related Data > Porosity Type Data (Oil & Gas only)

This column is used to display the porosity type data as symbols at specified depths. There are several ways to edit porosity type data, either:

 

•click on the porosity type data column on the log

•double click on the porosity type data object on the sidebar

•select Edit > Porosity Type

•or select Popup > Porosity Type

 

After this the Porosity Type form will be displayed. At the bottom of this form there are buttons to add and delete data.

 

(The appearance of the form will differ slightly depending on if it is WinLoG or WinLoG RT)

 

The following can be edited on this tab:

 

Depth: This is the depth to place the porosity type symbols.

 

Porosity Types: These are the porosity type symbols to display at this depth. The porosity type symbols can be selected from the list on the left by double clicking on them.