<< Click to Display Table of Contents >> Navigation:  Lab Analyses > Editing a Lab Analysis > Results Tab

The Results tab is used to specify the analytical results for the lab analysis.

 

 

The following can be specified on this tab:

 

Parameters: This is used to select the parameter group or individual parameter that was analysed. The parameters and parameter groups that can be selected can be edited in the Editing Parameters and Editing Parameter Groups sections.

 

Display Limit: Check this box to display and compare the results to a regulatory limit.

 

Regulation: This is used to select the regulation to use. Changing the regulation will also change the limits that can be selected. The regulations that can be selected can be edited in the Editing Regulations section.

 

Limit: This is used to select the limit for the selected regulation to display. The limits that can be selected for a regulation can be edited in the Editing ReEditing Regulation Limitsgulation Limits section.

 

Parameter:  This is the parameter being analysed for the selected parameter group.

 

Concentration: This is the concentration of the analysed parameter.

 

Limit: This is the regulatory limit for this parameter. If the analyzed concentration is higher than the regulatory limit it will be highlighted with the exceedence color specified in Preferences.

 

Units: This is the units for the concentration.

 

Descriptors: When a parameter is selected, this will display the results for the descriptors of that parameter. The Analysis Method, Preparation Method, EQL, and MDL descriptors are always present. All of the other descriptors are optional and can be edited in the Descriptors section.