<< Click to Display Table of Contents >> Navigation:  Chapter 11 Buildings and Structures > Structures > Editing a Structure > Scaling and Rotating a Structure

If the structure type is a building, shaft, or excavation they can be scaled and rotated by selecting Edit > Scale & Rotate or Popup > Scale & Rotate. The Scale & Rotate form will be displayed.

 

 

The following can be edited on this tab:

 

Angle: This is the angle to rotate the structure in degrees.

 

Clockwise or Counter-clockwise: This is used to select whether the structure is rotated clockwise or counter-clockwise.

 

Eastern Stretch: This is the percentage to stretch the structure in the east direction. A number smaller than 100% will reduce the size of the structure.

 

Northern Stretch: This is the percentage to stretch the structure in the north direction. A number smaller than 100% will reduce the size of the structure.