<< Click to Display Table of Contents >> Navigation:  Chapter 6 Cross-Sections > Cross Sections > Editing a Cross Section > Faults > Adding a Fault

 

Faults can be added by clicking on the Fault button on the toolbar or by clicking on the Fault object on the sidebar and then selecting Popup > Add. Click on the location of the starting point of the first line segment. Then while holding down the left mouse button, drag the cursor to the end point of the first line segment and release the mouse button. Continue to add the other line segments the same way. After the end point of the last line segment had been added, either click the right mouse button or double clicking the left mouse button. The Edit Fault form described in the next section will then be displayed.