Editing a Fault

<< Click to Display Table of Contents >>

Navigation:  Chapter 6 Cross-Sections > Cross Sections > Editing a Cross Section > Faults >

Editing a Fault

Previous pageReturn to chapter overviewNext page

The points on a fault can be edited by selecting the fault by clicking on it or clicking on it on the sidebar. Marquee boxes will then be drawn around the points of the fault. These points can be moved by clicking on them and dragging them to their new location.

 

Faults can also be edited by:

 

clicking on them on the sidebar

selecting Edit > Faults > Fault number or Popup > Faults > Fault number

double clicking on the fault

 

The Edit Fault form will be displayed.

 

clip0372

 

The following information can be edited on this form:

 

Point X: The fault is composed of a series of line segments between points. This is the horizontal position of the points.

 

Point Y: This is the vertical position of the points.

 

Use Curve Fit: Check this box to fit a curve to the fault points. Otherwise, straight line segments will be used to draw the fault.

 

Line Style: Click this button to change the line style of the fault. A Line Properties form will be displayed where the color, width, and style of the line can be specified.