Filter Tab

<< Click to Display Table of Contents >>

Navigation:  Chapter 4 Projects > Exporting Data > Exporting Charts > Creating a Geotechnical Test Chart >

Filter Tab

Previous pageReturn to chapter overviewNext page

The Filter tab is used to filter the data and only display the data that meets the filter criteria.

 

clip40626

 

The following can be specified on this tab:

 

Data Field: This is used to select the data field for the filter.

 

Condition: This is used to select the filter condition to apply to the selected data field. It can be  greater than, less than, between, equals, starting with, is null, or not null.

 

Condition Value: This is used to specify the value of the condition. It will be labeled Equals, Greater than, Less than,  Starting with, or Greater than and Less than depending on the condition selected.

 

Add: The Add button will add the specified filter to the list of current filters.

 

Remove: The Remove button will remove the selected filter in the list of current filters.