Porosity Grade Data (Oil & Gas only)

<< Click to Display Table of Contents >>

Navigation:  Chapter 4  Boring/Wells > Borings/Wells > Editing a boring/well > Depth Related Data >

Porosity Grade Data (Oil & Gas only)

Previous pageReturn to chapter overviewNext page

This column is used to display the porosity grade data based on the percentage of porosity. There are several ways to edit porosity grade data, either:

 

click on the porosity grade data column on the log

double click on the porosity grade data object on the sidebar

select Edit > Porosity Grade

or select Popup > Porosity Grade

 

After this the Porosity Grade form will be displayed. At the bottom of this form there are buttons to add and delete data.

 

clip0209

(The appearance of the form will differ slightly depending on if it is WinLoG or WinLoG RT)

 

The following can be edited on this tab:

 

Top Depth: This is the top depth for the data.

 

Bottom Depth: This is the bottom depth for the data.

 

Porosity Grade: This is used to select the percentage of porosity.