Defaults

<< Click to Display Table of Contents >>

Navigation:  Chapter 1 Introduction > Program Preferences >

Defaults

Previous pageReturn to chapter overviewNext page

clip40924

 

The following can be edited in the Defaults category:

 

Printer: This is used to select the default printer to use in some modules.

 

Location Precision: This is the precision (number of decimal places) to use when displaying location information.

 

Depth Precision: This is the precision (number of decimal places) to use when displaying depth information.

 

Decimal Degree Precision: This is the precision (number of decimal places) to use when displaying decimal degrees.

 

Lithologic Library: This is used to select the default lithologic library for some modules.

 

Dictionary: This is used to select the dictionary to use for some modules when performing spell checking. One of the following dictionaries can be selected: American, British, Dutch, English, French, German, Italian, and Spanish.

 

Auto Replace: If checked, common misspelled words will be automatically replaced when conducting spell checking.

 

Cache Resolution: This is the resolution to save images of borings/wells, cross-sections, and maps in the datastore. The resolution can be set to low (100 dpi), medium (300 dpi), or high (600 dpi). These images are used when displaying or printing a page document. Typically, low or medium is sufficient. The higher the resolution the more disk space and time is required when images are saved.

 

Character Set: This is used to select the character set used by some modules. Normally, the default character set can be used.

 

Most Recent: This is used to set the number of most recent objects (projects, borings, templates, etc.) to show.